Pharr Elite Concrete provides professional concrete resurfacing & overlays in Pharr, TX for residential and commercial properties across the Pharr area. Concrete resurfacing puts a new wear surface over a slab that is structurally sound but cosmetically finished, and when the slab qualifies it costs a fraction of tear-out and replacement.
The whole decision turns on one question we answer on the first visit: is the slab sound underneath?
An overlay is a surface treatment, not a structural repair, and bonding a beautiful new finish to a slab that is failing from below just gives you a beautiful new finish that cracks in the same places within a year.
Good candidates: surface spalling and scaling, worn or dated finishes, old discoloration and stains, minor pitting, a hard-trowelled garage floor you now want textured, a pool deck that has become too hot and too slick.
Bad candidates: a slab with active differential settlement, wide moving cracks, extensive delamination that sounds hollow when you drag a chain across it, or exposed and corroding rebar. In those cases we say so and quote replacement, because the alternative is charging you twice.
The overlay systems themselves come in several thicknesses for several jobs. Polymer-modified cementitious micro-toppings go down thin, from a skim coat up to about an eighth of an inch, and are used for color, texture and a clean uniform surface.
Spray texture, sometimes called a knockdown or splatter finish, is the standard for pool decks and patios because the texture is genuinely slip-resistant and it stays measurably cooler underfoot than a smooth surface, which matters here from May onward.
Stampable overlays go down around a quarter to three-eighths of an inch and take the same mats as a fresh pour, so an old plain patio becomes a stamped one without demolition.
Self-leveling underlayments handle interior floors that are out of plane before a finish floor goes down. Preparation is the entire job.
Every system needs a mechanically profiled surface, which means diamond grinding or shot blasting to open the concrete, not an acid wash and a hope. Existing sealers, curing compounds, paint and adhesive all have to come off.
Cracks get treated and, where they are moving, honored with a joint in the overlay rather than bridged, because a crack that moved before will move again. Existing control joints get carried through.
Done that way, a good overlay lasts and looks like a new slab. Done over a dirty, sealed, unprepared surface, it delaminates in sheets and everybody is unhappy.
With 15+ years of experience, our licensed and insured team brings the right materials and equipment to every job — 3,000 to 4,500 PSI mix designs, water-cement ratio control, #3 and #4 rebar on chairs, polypropylene fiber-mesh reinforcement, control, construction and isolation joints, 95 percent standard Proctor subgrade compaction — and backs the work with a written workmanship warranty. We serve Pharr and nearby communities including McAllen, Edinburg, Mission, Weslaco.
What We Handle
Everything our concrete resurfacing & overlays in Pharr covers
One crew, one point of contact, and the full range of concrete resurfacing & overlays work in Pharr, TX. If it is on this list we do it in house rather than handing it to a subcontractor:
- concrete resurfacing
- concrete overlay
- micro-topping overlay
- stamped concrete overlay
- spray texture deck coating
- self-leveling underlayment
- driveway resurfacing
- pool deck resurfacing
- garage floor resurfacing
- concrete resurfacing cost
- worn concrete restoration
- polymer modified overlay
Not sure which one describes your situation? Describe it in plain words and we will sort it out — or browse the rest of our Pharr services.
Materials, equipment and how we do concrete resurfacing & overlays
The difference between concrete resurfacing & overlays that lasts and concrete resurfacing & overlays that gets redone in three years is almost always preparation and materials, not the finish you see on day one. We work with 3,000 to 4,500 PSI mix designs, water-cement ratio control, #3 and #4 rebar on chairs, polypropylene fiber-mesh reinforcement, spec them to the job instead of to the invoice, and write the material grades into the free estimate so you know exactly what you are buying.
Every Pharr job runs the same way: site walk and measurements, written scope and fixed price, protection of the surrounding area, then the work itself with a daily clean-up. 15+ years of concrete work in the Pharr area means we have already met whatever your property is going to throw at us — awkward access, older construction, an HOA with opinions.
Where we do concrete resurfacing & overlays outside Pharr
Pharr Elite Concrete covers Pharr and the surrounding communities of the Pharr area. Crews run out to the same nearby cities every week, so an out-of-town job does not mean an out-of-town price.
- Concrete Resurfacing & Overlays in McAllen, TX — Hidalgo County, incorporated in 1911, population 142,210 at the 2020 census
- Concrete Resurfacing & Overlays in Edinburg, TX — Hidalgo County, incorporated in 1919, population 100,243 at the 2020 census
- Concrete Resurfacing & Overlays in Mission, TX — Hidalgo County, incorporated in 1910, population 85,778 at the 2020 census
- Concrete Resurfacing & Overlays in Weslaco, TX — Hidalgo County, population 40,160 at the 2020 census
- Concrete Resurfacing & Overlays in San Juan, TX — Hidalgo County, population 35,294 at the 2020 census
- Concrete Resurfacing & Overlays in Alamo, TX — Hidalgo County, incorporated in 1924, population 19,493 at the 2020 census
Start on the Pharr Elite Concrete homepage for a free estimate, or call (844) 511-2320 and describe the job.
Why Pharr Chooses Pharr Elite Concrete
- ✓Over 15 years pouring concrete across the Rio Grande Valley
- ✓Every quote states the mix strength, the thickness and the reinforcement
- ✓Subgrade compacted and tested before a single form goes in
- ✓Control joints cut on a calculated grid, not wherever it looks even
The standards behind concrete resurfacing & overlays
Quality here is not a matter of opinion — it is written down. The concrete resurfacing & overlays work we do in Pharr follows published industry standards: American Concrete Institute is the code body for mix design, curing and joint spacing, and NRMCA sets ready-mixed delivery and placement practice. If a contractor cannot tell you which standard a detail comes from, that is worth asking about before you sign.
Every concrete resurfacing & overlays project in Pharr gets the same attention, whether it is a single room or a full commercial job. We show up on schedule, keep the site clean, and stand behind the work — the estimate is free and there is no pressure.
Ready to get started? Call (844) 511-2320 for a free concrete resurfacing & overlays free estimate in Pharr, or request a quote and we'll get right back to you.